Can You Clean a Pipe with Hydrogen Peroxide?

Glass pipe with weed in the bowl

Shop this article

View all
Delta-8 RelaxSold out
Delta-8 RelaxSold out
Delta-10 Sativa
Delta-10 Sativa
Delta-8 Indica Sleep
Delta-8 Indica Sleep
Delta-8 Focus SativaSold out
Delta-8 Focus SativaSold out
Table Of Contents

Cleaning your pipe regularly is one of the most important things you can do to have a good smoke. When you let tar and resin accumulate in the pipe, it doesn’t matter if you have a top-shelf flower; the taste will be disgusting.

Among the many ways you can clean a pipe, many smokers recur to hydrogen peroxide. But, can you clean a pipe with hydrogen peroxide? In this article, you’ll learn more about this.

Key Takeaways

  • Hydrogen peroxide is effective in cleaning glass pipes, as it acts as an antiseptic to eliminate germs inside the pipe.
  • For wooden pipes, hydrogen peroxide can be used as a bleaching agent and disinfectant. It's also suitable for metal pipes, though it may cause some color fading.
  • To clean pipes with hydrogen peroxide, it's recommended to soak them in a 3% hydrogen peroxide solution for about an hour. For wooden pipes, a mix of equal parts hydrogen peroxide and water is recommended, followed by a rinse with warm water.
  • While hydrogen peroxide is safe for cleaning pipes, caution is advised regarding the amount used, especially for pipes with metal parts, as it is a strong oxidizer and can cause damage if misused.
  • It's also important to store the pipe in a cool, dark place after cleaning to prevent the breakdown of hydrogen peroxide due to light or air exposure.

What is Hydrogen Peroxide?

Hydrogen peroxide is a colorless oxidizing agent. When diluted with water (usually), hydrogen peroxide becomes safe for use as a disinfectant and cleaning agent.

Like all acids, hydrogen peroxide reacts with bases such as soda (sodium bicarbonate) and baking soda (sodium carbonate). The reaction between these two substances results in the formation of carbon dioxide gas, which bubbles off into the atmosphere.

Can You Clean a Glass Pipe with Hydrogen Peroxide?

Hydrogen peroxide is an antiseptic that can eliminate germs from the inside of glass pipes, but it doesn’t remove any residue or dirt on the outside of the pipe. Additionally, hydrogen peroxide will break down when exposed to light or air. Therefore, it is best to store your pipe in a cool, dark place after using this cleaning method.

Is Hydrogen Peroxide Safe to Clean Pipes?

Yes, it is safe to clean your pipes with hydrogen peroxide. However, you should be cautious about the amount you use. Hydrogen peroxide is a strong oxidizer that can cause damage to any metal parts of your pipe if misused.

The best way to clean your pipes with hydrogen peroxide is to soak them in a solution of 3% hydrogen peroxide for about an hour before using any other cleaning method. This will loosen any dirt and grime that may be stuck inside the pipe and allow it to come out easily.

You may also want to consider using a mild detergent and hydrogen peroxide solution when cleaning your pipes. This will help remove any residue left behind by soap scum or other buildup that might remain after using just hydrogen peroxide without any additional cleaning products added to the mix.

Can You Clean a Weed Pipe with Hydrogen Peroxide (Non-glass)

Wooden Pipes

Wooden pipes are a great alternative to glass since they're more durable and less likely to shatter if they fall. They also come in various shapes and sizes, so you can find the one that best fits your needs.

Wood is a porous material, so it's not surprising that it can absorb some residue over time. If you're looking to clean your wood pipe, you might consider using hydrogen peroxide.

How to Clean Wood Pipes with Hydrogen Peroxide

Hydrogen peroxide is a bleaching agent and oxygenated bleach, which means it will remove stains from your wood pipe by oxidizing them. It's also an antiseptic and disinfectant, so it'll get rid of any germs or bacteria that might have attached themselves to your pipe.

To clean your wooden pipes, mix equal parts of hydrogen peroxide and water in a bucket or bowl. Then soak your pipe in this solution for at least 20 minutes before rinsing with clean water. Finally, rinse your wooden pipe off with warm water (not hot) and allow it to dry completely before smoking again.

Metal Pipes

Metal pipes are another common alternative to glass pipes. They come in a wide variety of shapes and sizes, but they're typically more expensive than wooden pipes.

Hydrogen peroxide is a natural disinfectant and can be used to clean your metal pipe. However, like all cleaners, it should be used sparingly because too much of it can be harmful.

To clean your metal weed pipes with hydrogen peroxide, pour some into a bowl or cup and submerge the pipe in it. Let it sit for 10 minutes. Then scrub the pipe with an old toothbrush and rinse thoroughly. Finally, wipe down the pipe with a paper towel and it's ready to go again.

Hydrogen peroxide is a mild bleach, so it will clean your weed pipe and kill any germs or bacteria. It will not damage the metal, but it may make some of the colors on your pipe fade. You can use this method to clean a glass or metal pipe and other smoking accessories like bowls and screens.

How To Clean Glass Pipes with Hydrogen Peroxide

When it comes to cleaning your glass pipe, there are a lot of methods that work well. Equally, hydrogen peroxide is one of the best ways to deep clean your glass without damaging it. It is a bleaching agent and disinfectant, so it works well inside and outside your pipe. Here's what you'll need:

  • Bowl of hot water.
  • 1/2 cup of hydrogen peroxide.
  • A container (a jar with a lid works best).

Step 1: Add warm water to the container

If there's any residue inside your glass pipe, you need to remove it before using hydrogen peroxide. To do this, fill up your sink with warm water and add some dish soap into it before submerging your pipe into the water.

Let it sit in the water for 10 minutes so that all of the residues can dissolve. Take out the pipe and rinse out all the soap with fresh water until the soap is gone from inside of your pipe. Finally, wipe down all surfaces on both sides of your glass piece with paper towels until they're clean.

Step 2: Pour the water and rinse the container thoroughly with hot water

Use soap if necessary to remove all traces of residue from inside the pipe or bong. Rinse again with cool water until all soap is gone from both sides of the glassware, as soap can leave residue on surfaces that can affect the taste.

Step 3: Add the hydrogen peroxide

This is done by pouring it into a small dish and placing your pipe inside this solution. Make sure that you don't pour too much in or get any on your hands. You want to be careful not to make a mess, but you also want enough hydrogen peroxide to help clean out any gunk that's built up inside the pipe.

Step 4: Let it sit for 20 minutes

After adding your hydrogen peroxide, let it sit for 20 minutes. You can swirl the hydrogen peroxide around in your pipe. This will help remove any buildup that may be present on the inside of your pipe.

Step 5: Rinse with water

Rinse off your glass pipe with warm water until all traces of hydrogen peroxide are gone from its surface. Be careful not to use hot water because this can cause cracks in your glass pipe's surface.

Once your pipe is as good as new, what about smoking the deliciously pungent Sour Lifter strain? This energizing bud is the best reward you can give yourself after several hours of cleaning your pipe.

Reading next

Live resin on parchment paper
Cannabis plant